kayvann
Report

Easter Bunny and Eggs Home Decor - With Frame

Instruction
EasterBunny&EggLayers.xcs
EasterBunny&EggLayers
.xcs
Application scenario
Laser processing (10min)
Machine & module
xTool D1 Pro
20W
Compatibles · 10
Material used
3mm Basswood Plywood
84
491
Information
      This is a set of one Easter bunny and two Easter eggs.
The design is two layers with patterned paper between the layers.
    
Instruction
1
Step1
Preview

To get started, choose your patterned paper (any paper will work), you can even use fabric!

Choose your stain choice (optional, I just stained the top frame layer).

Have a brush and mod-podge ready.

Grab the wood you'll be using for your cuts and bush a thick-ish layer of mod-podge on it. 

Immediately place your paper on the mod-podge and start brushing on a layer over top the paper. Since mod-podge is transparent, you wont have to worry about it showing on top once it is dry.

*The layer of mod-podge on top of the paper makes it much easier to wipe off and charring from cutting the wood.

 

Once your glue is dry under and on top of the paper, you're ready to cut!

2
Step2
Preview

Cut your bottom layers on the wood you just glued your paper to. The frame can be cut on a separate piece of wood without the paper.

Once your frames (top layer) are cut, use super glue to glue the frame on top of the patterned paper and thats it! Now you have cute, handmade Easter decor!

Comments
Remixes
xTool Supplies Used in This Template
xTool D1 Pro
xTool D1 Pro
3mm Basswood Plywood
3mm Basswood Plywood