HomeTemplatesDecorHome DecorLighting
winniewalker85
Report
[Laser cut and engrave] Wooden candle holder with tree and yoga figure design
Project made with xTool D1 Pro machine for Laser cut and engrave.
Project made with xTool D1 Pro machine for Laser cut and engrave.
[Laser cut and engrave] Wooden candle holder with tree and yoga figure design
Project made with xTool D1 Pro machine for Laser cut and engrave.
[Laser cut and engrave] Wooden candle holder with tree and yoga figure design
[Laser cut and engrave] Wooden candle holder with tree and yoga figure design
[Laser cut and engrave] Wooden candle holder with tree and yoga figure design
[Laser cut and engrave] Wooden candle holder with tree and yoga figure design
[Laser cut and engrave] Wooden candle holder with tree and yoga figure design

yoga tree tea light

Instruction
yogacandleholdertest.xcs
yogacandleholdertest
.xcs
Application scenario
Laser processing
Machine & module
xTool D1 Pro
10W
Material used
3mm plywood
11
202

Information

      from one sheet of 3mm ply, little yoga tree to light up the back wall.

Instruction

1

Step1: yoga tree candle light

yoga tree tea light instruction: step 1 - yoga tree candle light
Preview

simply open with xcs, laser cut it then place all parts on table. Then glue little circles together to form the legs, rings together for tea-light holder and glue them onto base. I've since spray varnished it but not sure if it looks any better or worse.

total time taken was 20-30 minutes (5 machine running minutes).

Comments

Remixes

xTool Supplies Used in This Template

xTool D1 Pro
xTool D1 Pro

License

CC BY-SA