HomeTemplatesToys & Games & ModelsBoard Games
Gena
Report
[Laser cut and engrave] Gift Exchange Dice Game
Project made with xTool P2 machine for Laser cut and engrave.

Gift Exchange Dice Game

Instruction
Gift Exchange 2023 Final in Groups.xcs
Gift Exchange 2023 Final in Groups
.xcs
Application scenario
Laser (120min)
Machine & module
xTool P2
55W
Material used
1/4" Birch
Birch Plywood
216
2986

Information

      I made this as a fun alternate to Dirty Santa for our family. We were originally going to play three rounds and changed it to five rounds. (We had Christmas early this year.)

Instruction

1

Step1: Pre-stain wood and let dry before processing

Gift Exchange Dice Game instruction: step 1 - Pre-stain wood and let dry before processing
Preview

I usually wait 24 hours after I stain wood before processing. After processing I immediately take projects to the kitchen sink and wash under running water to get the residue off then towel dry.

2

Step2: Score, Engrave & Cut Base Layer then cut Top Layer for Frame

Gift Exchange Dice Game instruction: step 2 - Score, Engrave & Cut Base Layer then cut Top Layer for Frame
Preview

I rotated this project 90 degrees to get the maximum size in slats flat mode w/honeycomb and it was 11.25" wide by 13" high. I believe it took longer to process this way. Attempt #2 will be upright using conveyer so I can make it larger.

3

Step3: Spray with Clear Coat

Gift Exchange Dice Game instruction: step 3 - Spray with Clear Coat
Preview

My favorite spot to spray aerosol is on my trashcan! I bring it into the garage to let it dry completely. 

4

Step4: Glue it together!

I use Starbond THICK from Amazon. It just takes one little dot per inch without leaving residue.

Comments

Remixes

xTool Supplies Used in This Template

xTool P2
xTool P2