HomeTemplatesDecorHome Decor
herbhalstead
Report
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

EVA Foam Coasters

Application scenario
Laser (720min)
Machine & module
xTool M1
Material used
5mm EA Foam (Black)
1279
Information
      These are 80mm x 80mm EVA foam coasters with my company logo engraved. I placed the whole sheet into the machine on the honeycomb at the top slot. I could not use the magnetic clips because the foam peice was too large so I used masking tape to hold the foam secure. Cutting the coasters may take more passes. Just try to pop one out and if it does not come out, turn output OFF for logos, then reprocess only cuts.
Comments
Remixes
xTool Supplies Used in This Template
xTool M1
xTool M1