This file contains both the “mostly" completed ornament, as well as the outer blank.

Click the outer blank and set it to ignore (or delete it) to continue with the completed ornament.

(The blank is just there so you can pratice with your own).

Select “Text” on the left hand side and type out your desired text

Pick a font for the text

Resize the text to fit into the “text area” on the ornament - ensuring that the top and bottom of the text just barely reach above and below the text area.

Select both the text and the ornament and on the top of XCS hover over “combine” and then click on “Unite”

Now that your ornament is finalized, you can opt to cut it out on most any of the xTool machines!