Easter bunny egg cup
Instruction
An egg cup stand with an Easter bunny figure.
Easy to make and assemble. It will hold a variety of sizes.
The design should be made with a 3 mm thick material.
For assembly, you will need the following parts:
- Laser cut parts
- Wood glue
- Optionally some tape and a toothpick to apply the glue
- Optionally some paint to paint the parts
If you plan to paint the parts I suggest you do it now, before you start with assembly.
I added a bit of tape to the bottom of the base, to prevent glue from coming out and gluing my part to the table.
Apply glue to the bottom of the arm, where it mates with the base, as shown in the picture. I use a toothpick to apply small amounts of glue.
Insert the arm in to the base.
Repeat the process for the rest of the arms.
Apply glue to the top of the arms, where they mate with the top part, as shown in the picture.
Slowly install the top part, making sure that the arms are aligned.
Firmly press everything together to ensure a tight fit.
If you wish, you can glue in the bunny figure. Or just insert it without gluing it for removal later.
Apply the glue where the figure mates with the top part.
Wait for the glue to fully cure. The bunny figure makes the part a bit unstable if empty.
Add one egg in the basket and you are ready.