Report
Inch to Metric & Fraction to Decimal Conversion chart on wooden surface.
InstructionConversionChart
.xcs
Application scenario
Laser processing (120min)
Machine & module
xTool D1 Pro
10W, 20W, 40W
xTool S1
10W, 20W, 40W
xTool P2
55W
xTool P2S
55WCompatibles · 7
Material used
3mm Basswood Plywood
42
391
Information
When I work on different project there are many times that I may need to look up a conversion charts on the web. It honestly got to be a pain in the butt constantly having to go back and forth to different sites or calculators to get what I needed. I made made this to convert in to xcs that engraved on wood so you can have it on hand anytime you need to look up a conversion from inches to mm or fractions to decimals. If you are tired of looking at different sites or going to calculators to find your conversions this may just help you. The power settings I am giving are for the D1 20 watt you can use this file for the S1 and P2 but may have to adjust the settings depending on which machine you use and wattage.
Instruction
1
Step1
Once you engrave and cut on one side just take out the cut while leaving the rest of the wood in place.
2
Step2
Flip wood over then put it back in the original cut hole or cut square. Once you do that adjust the cut setting to score power 1 and speed to 50 leave the engraving setting the same.
Comments
Remixes
xTool Supplies Used in This Template