Report
BAE Hawk jet airplane
Instruction3mmBAEhawk
.xcs
Show 3 more
Application scenario
Laser processing
Machine & module
xTool S1
20WMaterial used
3mm plywood
2mm plywood
3mm cardboard
.050 matboard
53
265
Information
This is a very simple model of the BAE Hawk advanced jet trainer as used by many air forces, as well as by the RAF Red Arrows aerobatics team. I have included files to let you use a range of material thicknesses including 2 and 3mm plywood or cardboard as well as .050 inch matboard.
Make a whole team of nine for yourself!
Instruction
1
Step1: Cut kit card
Preview
Leave the parts attached to the kit card until you are readyy to assemble. This model is one made from the .050 inch matboard.
2
Step2: separate the parts from the frame
Preview
Use a sharp craft knife to remove the parts from the frame. Make sure that you remove all the tabs cleanly while the parts can be laid flat on your cutting mat.
3
Step3: glue on the wing
Preview
Use a small amount of white glue to stick the pieces together.
4
Step4: glue on the tail
Preview
Glue the tail in place using a small dab of white glue. Set aside to dry.
Comments
Remixes
xTool Supplies Used in This Template