HomeTemplatesTools & Special MaterialsJigs
alex.verna.dj
Report
Laser cut and engrave
Project made with xTool F1 machine for Laser cut and engrave.
Project made with xTool F1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

F1 jig 2 metal business card 85mm x 53mm

Instruction
jig2cartedimetallo.xcs
jig2cartedimetallo
.xcs
Application scenario
Laser processing (30min)
Machine & module
xTool F1
2W, 10W
Compatibles · 8
Material used
6mm Basswood Plywood
37
635
Information
      i had made this jig that you can insert inside the F1 plate using the 6mm polywood.
Instruction
1
Step1: Load the file and the material in the machine

load the file on creative studio, and insert in the machine the material you choose 

2
Step2: Select the material you choose to use in the xcs material list

if you choose another material different from the 6mm polywood adjust the setting for the material you choose and then push play !

3
Step3: Refine the finish product if you need
Preview
Preview

if you used the same material as me, use a small piece of sandpaper to clean the wood and to finish the sides because unfortunately the cut will come out a bit conical typical of the galvo laser

Comments
Remixes
xTool Supplies Used in This Template
xTool F1
xTool F1
6mm Basswood Plywood
6mm Basswood Plywood

License

CC BY-NC