You will need a 2-3oz leather (1mm) thick leather. Anything thicker and this project might not come out as good.

First make sure your leather is oiled up and colored. If your leather is already colored than your set.

Take the matching leather band pieces and stitch them together using a saddle stitch.

You should have 2 bands completed after this task.

Now using the leather buckle tab, attach your buckle using a rivet or chicago screw.

Connect the two ends of your strap keepers with thread or staple and slide them over the band with the buckle.

Now attach your spring bar tabs to the ends of your straps with rivets or chicago screws.

Stitch together your bund section and make sure you stitch the correct strap keepers at the ends of your bund sections.

Now attach your watch case to each end of your watch straps.

Slide each end threw the top and bottom keepers of your bund section.

Finished.