HomeTemplatesTools & Special MaterialsJigs
jim.murr
Report
Laser cut and engrave Wooden handcrafted architectural model
Project made with xTool P2S machine for Laser cut and engrave.
Project made with xTool P2S machine for Laser cut and engrave.
Laser cut and engrave Wooden handcrafted architectural model
Laser cut and engrave Wooden handcrafted architectural model
Laser cut and engrave Wooden handcrafted architectural model
Laser cut and engrave Wooden handcrafted architectural model

Material Alignment Jig for P2S

Instruction
XYZ-FINAL.xcs
XYZ-FINAL
.xcs
Application scenario
Laser processing
Machine & module
xTool P2S
55W
Compatibles · 7
Material used
6mm Basswood Plywood
21
607
Information
      Perfectly square up material to the laser head. This jig needs to be used only when the  machine is off and the arm is free to move forward and back. The jig fits over the arm and just clears the slats or the honeycomb.
Instruction
1
Step1

After cutting the pieces, dry fit everything together. I used wood glue and clamped the two 1-½" pieces to the 3 notched ‘L’ shaped pieces. To make sure the jig was square, I clamped a small triangle to insure the 90 dg angle, while the pieces dried. After, I removed the clamps and glued the 1" pieces and finally the two ‘L’ shaped pieces, re-clamped everything till dry.

Comments
Remixes
xTool Supplies Used in This Template
xTool P2S
xTool P2S
6mm Basswood Plywood
6mm Basswood Plywood

License

CC0