HomeTemplatesDecorSeasonal & Themes DecorHolidays Decor
thecreativebutton
Report
Laser cut and engrave Happy Easter greeting card with bunny and flowers
Project made with machine for Spring.
Laser cut and engrave Happy Easter greeting card with bunny and flowers
Laser cut and engrave Happy Easter greeting card with bunny and flowers

Easter Bunny table stand with flowers

Instruction
EASTERBUNNYSTAND2.svg
EASTERBUNNYSTAND2
.svg
7
173
Information
      A cute addition to a spring table. A design that integrates all the pieces but also allows them to be painted separately for clean lines. Double sided and change the message is you wish.
Cut on 6mm basewood.
Instruction
1
Step1
  1. Place your 6mm basewood on the slatted bed and secure.
  2. Ensure you have the correct settings for power and speed. (I use 95% power and 12 for speed) This is for guidance only but has produced good results)
  3. Ensure you have changed the engraving setting for the original message or create a different message. ( I used 25% Power and 270 for speed)
  4. Once you have cut the pieces clear and dust. 
  5. Apply a primer or acrylic paint to both sides and the edges separately. With wood glue slot in the stand piece. Paint the stand as one piece. This may take a few layers to achieve a good finish. Once all the pieces are dry glue the remaining pieces. Flower middles first, then the flowers and finally the bunny. 
  6. You may wish to seal with a clear varnish for extra protection.
Comments
Remixes

License

Standard License