Use my settings, and cut the design. You can make it bigger, if you want (or smaller, but please be sure that it's not too small, it might will broke at the hole).

I have used 3mm pine plywood, and scored & cut with M1 10W machine.

I used white lasur gel, and added it to both sides, to the center and to the edges. I added a very thin layer only, and wiped it off with a tissue paper.

Wait until it dried.

I used red and pink pencils (very basic ones) to add a bit of colors. It is a faded one, looks beautiful.

Add 1-1 rings to the earrings, then another one with the earring hoops. Then, you are ready!

Show it below, if you made it.