![[Laser cut and engrave] Handcrafted felt flowers in various shades of blue and white](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/a9b83793-2012-40fc-a8fe-7199fb015e94?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Easy laser-cut felt flowers
Instruction
Information
This is a beginner project, only a few pieces of felt shapes, and you can assemble in a few minutes.
Instruction
Step1: Cut
I am using 1mm wool-felt for this project. The edges might be a bit burnt, you can gently clean it with (cold) water. The settings might be different for different types of felt; I tried a lot of settings, and a lot of felt too, this is the best I could make.
The white long strip can be any any length (for 6 flowers, it should be around 15 cm, but it depends on your felt fabric.
You will need hot glue gun with sticks, scissors, and floral wire.
Step2: Flower bud
You need to start with the flower bud. Add a bit of glue to the end of the white felt (~2 - 2.5 cm would be enough), put the wire end to the very end of this felt scrap, and start rolling. You can decide, how big you want to have this bud; mine is around 2.5 cm. (I did not want to make it cut, because it is easier to work with a longer strip).
If your bud looks like mine, you can cut the end. If you have some felt at the end, which is not rolled perfectly, you can add glue to it, and press gently to have the same look as me.
Step3: Add the flower and glue
Cut a small hole to the center of your felt flower, and pull it thru to the end of the wire. Pull it up close to the bud, and add s small amount of glue to the center of the flower. Move it up to the bud, and hold it together a bit. You can add a small dot of glue to any loose flower petals. You might need to make a few to practice, but I am sure - at the end, you'll be satisfied with your bocquet!
Make it in different colors! :)
