HomeTemplatesDecorHome DecorWall Art
ars1908mau02
Report
[Laser cut and engrave] Intricate wooden carving of a punk skull with spikes and chains
Project made with machine for Laser cut and engrave.
Project made with machine for Laser cut and engrave.
[Laser cut and engrave] Intricate wooden carving of a punk skull with spikes and chains
[Laser cut and engrave] Intricate wooden carving of a punk skull with spikes and chains
[Laser cut and engrave] Intricate wooden carving of a punk skull with spikes and chains
[Laser cut and engrave] Intricate wooden carving of a punk skull with spikes and chains

Steampunk skull

Instruction
mohawkskull_AIburnme.png
mohawkskull_AIburnme
.png
41
271

Information

      This is an engraving from digital design into a 3mm wood sheet. 
Two simple steps; engrave the file and cut the perimeter. All can be done in the same session. The machine used for these wall art piece was a XTool S1. The material was XTool basswood 3 mm sheet.

Instruction

1

Step1


Recommendations: place the material over a honeycomb panel for better cutting performance. Use the magnets to secure the material and set the air assist on auto. 

Start the process.

Comments

Remixes

License

CC BY-NC