Wooden earrings with engraved design

Use my settings (10W M1 machine), and engrave & cut the design. 

I choosed a gel lasur for this design, which gives a very nice coat on these earrings. 1 layer of this is enough.

I am applying it with a sponge - you can use a roller too - , with that I can make sure that the lasur is not going into the engraved parts.

I start with the back of the earring, so I can see the amount of paint needed. Once it is dried, I can move to the front part. Then, I need to wait for drying again.

You can add a lacque coat too - I decided to keep it matt-ish.

You'll need 2-2 rings, and 1-1 earring hoops to apply. (If you resize the design, please make sure that you move to hole, and keep it the right size.

Now, you are done. :) Share your version, if you made it.