HomeTemplatesToys & Games & ModelsBoard Games
wafoij
Report
[Laser cut and engrave] Connect 4 Game
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
[Laser cut and engrave] Connect 4 Game
[Laser cut and engrave] Connect 4 Game
[Laser cut and engrave] Connect 4 Game
[Laser cut and engrave] Connect 4 Game

Connect 4 Game

Instruction
Connect4(shared).xcs
Connect4(shared)
.xcs
Application scenario
Laser processing
Machine & module
xTool S1
10W
Compatibles · 11
Material used
1/8"(3mm) Basswood Plywood
1/8"(3mm) Walnut Plywood
246
1320

Information

      The popular connect 4 games with enclosure to pack everything away neatly

Instruction

1

Step1: Build the holder

  1. Cut out the holder pieces
  2. Glue and install the dividers on one side of the main piece
  3. Glue and install the other side of the main piece
  4. Install the side pieces last
2

Step2: Build the enclosure

  1. Cut and build the enclosure (red layer)
  2. Cut out the internal supports (blue layer)
  3. Glue the internal supports to the inside of the enclosure in the designated areas (marked out by the purple layer)
3

Step3: Engrave and cut the chips

Steps 1 & 2 Optional if using different coloured wood or painting the chips in different colours afterwards

  1. Cut out the rectangular outlines surrounding the chips
  2. Use the corners to line up with crosshair and engrave the X's & O's on both sides of the plywood
  3. Cut out the chips once engraving done on both sides
Comments

Remixes

xTool Supplies Used in This Template

xTool S1
xTool S1
1/8"(3mm) Basswood Plywood
1/8"(3mm) Basswood Plywood
1/8"(3mm) Walnut Plywood
1/8"(3mm) Walnut Plywood

License

CC BY-NC-SA