A small forest scene with animals and a colorful tree

Paint a plywood board in bright colors, the size of the tree (approximately 20cm x 20cm in area)/ (7,87 x 7,87 Zoll) and wait until everything is dry well. 

Try to apply the colors thin on the plywood to avoid a thick coating of acryl color. 

1. Prepare the Laser Cutter:

• Load the 4mm Plywood into your laser cutter.
• Open the design file in Creative Space Software and ensure the layout fits within the material boundaries.
• Secure the plywood to the laser bed to prevent movement during cutting.
• Swap the tray to the honeycomb tray or add raiser under the 4mm Plywood
• (Optional) Use some tape to hold down the board if needed. 
• Enable the output 

2. Set Cutting Parameters:

• Adjust the laser focus height and define the cutting boundaries according to your material and machine specifications.
• Double-check settings to ensure clean cuts.

3. Run the File:

• Start the process of removing the paint 
• Then cut it out 

If you want, you can paint the base plate with green acrylic paint as shown in the picture. A bit rough and uneven, but this gives a good impression of grass.

You can achieve this by first painting everything with a sponge or brush, and then dabbing and brushing in a crisscross pattern.