Use my settings (M1 10W) to cut out the design. (You can adjust size, but please note that if yu make it smaller, the lines might will be too thin)

You can use any colors, and any kind of paint for this step. (If you have M1 ultra, even print that on).

I used Posca acrylic markers to fill the colors; black and silver this time. I use simple black for the back side (so you might can change the direction, and then you have 2 earrings in one :) )

Wait until the paint is dried.

Add a light coat of lacque / varnish / UV resin to make it shine, and more durable.

Wait until it dried; apply it to both sides, and aside, between the lines too.

Add earring settings, and you are ready to use.