YD
Report

How to make a S1 Cut test grid

Instruction
S1_TestFile_MakeYourOwn.xcs
S1_TestFile_MakeYourOwn
.xcs
Application scenario
Laser
Machine & module
xTool S1
40W
Compatibles · 8
Material used
Birch Plywood
3085
19596
Information
      I see many folks asking for cut test files for the S1. It is much better to make your own. These instructions work across all XTool machines that use XCS but also for the S1.
    
Instruction
1
Step1: Add a rectangle
Preview

Select "Insert" from left navigation bar, then choose "Rectangle"

Drag a small rectangle out on work area. I like to make mine about 7mm x 7mm.

2
Step2: Set Rectangle to Cut
Preview

While the rectangle is selected ensure "Cut" is selected in under "Processing Type" in right nav bar

3
Step3: Create Array
Preview
Preview

While the rectangle is selected click on "Array" on top bar, then select "Material test array"

Adjust power and speed parameters, for my wood materials I use power in the 40-100 range, speeds in the 3-12 range(lower for thinner, higher for thicker).

You can add or subtract rows and columns to get more even values on your grid. 

Once gird is ready you can tell it is good when you click on it and under "Processing type" it says *Multiple values.

Frame and process as normal.

Do not leave unattended when doing these tests especially as the higher power can easily ignite your material. 

Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1