stephcreated
Report

Christmas pin with reindeer and Merry Christmas text

Instruction
christmaspin.xcs
christmaspin
.xcs
Application scenario
Laser processing
Machine & module
xTool M1 Ultra
20W
Compatibles · 10
Material used
3mm Basswood Plywood
4
229
Information
      Make these fun christmas pins.
    
Instruction
1
Step1: Prep your material
Preview
  • Start out by sanding your wood very well.
  • In order for your print to come out well on wood you will need to prime with the a clear coat.
    • For this project. I used modge podge spray.
2
Step2: Print and Laser
Preview
Preview
Preview
  • Place your wood inside your machine
  • Make sure you are in the inkjet printing setting in processing mode
  • Print your image.
  • Once it's done DO NOT MOVE  your material
    • replace the inkjet module with the laser module
  • Change your module mode to lasering on flat surface
  • Turn off the output of the image by again clicking on it and turning off the the output
  • Click Go to Process
3
Step3: Assembly
Preview
Preview
  • Grab your glue and your backing of choice
  • You can also use UV Resin to attached the backing.
  • If you are using UV Resin go ahead and resin the front to give it a more polished look and to protect the print!
  • If not using resin, you can spray the front with some more modge podge for protection.
Comments
Remixes
xTool Supplies Used in This Template
xTool M1 Ultra
xTool M1 Ultra
3mm Basswood Plywood
3mm Basswood Plywood