stephcreated

Report

Thanksgiving place card

Instruction

ThanksgivingPlaceCard

.xcs

Application scenario

Inkjet printing、Blade cut、Pen drawing

Machine & module

xTool M1 Ultra

20W

Material used

cardstock

188

Information

      Use your machine to great Thanksgiving place setting cards

Preview

Select your design you want to use.
- Here I decided to use a turkey for thanksgiving
Create a box 4" x 3.5"
Create a text box with the text you would like to use
Arrange the design and text inside the box.
- You want to make sure your photo and text are more towards the bottom of the box so when you fold it over it will be on the right side.

Preview

4 More images

First set up your sticky mat and cardstock in your laser
Change the processing type to inkjet printer
After it prints you want to change the processing type Pen
- Put your pen in the pen adapter and place in machine like shown in third photo.
- Select your pen settings, for this design I used “fill”
Once done, make sure that the box around the photo and text is turned off. You can do that by clicking on the box and making sure the output is not green, as shown in the fourth photo.
Once that is done processing switch the processing type to Blade
Remove the pen and install the blade
Make sure the text that the pen just created is now turned off OR your blade will cut the text!
Make sure all your settings are correct and process your cut.
- I am using a 176g cardstock in this project and found 80 power / 80 speed / 2 passes worked for me. If you are using a lighter or thicker cardstock you will need to adjust your settings.

Preview

Fold over your project as shown in the photo and set it up on your table for your guest.

Comments

xTool M1 Ultra