Trick or treat ghost pin

Instruction

halloweenpin

.xcs

Application scenario

Laser processing

Machine & module

xTool M1 Ultra

20W

Compatibles · 12

Material used

1/8"(3mm) Basswood Plywood

412

Information

      Make this cute pin or hand out for trick or treating or just to wear for Halloween!

Preview

Start out by sanding your wood very well.
In order for your print to come out well on wood you will need to prime with the a clear coat.
- For this project. I used modge podge spray.

Preview

Place your wood inside your machine
Make sure you are in the inkjet printing setting in processing mode
Print your image.
Once it's done DO NOT MOVE your material
- replace the inkjet module with the laser module

Change your module mode to lasering on flat surface
Turn off the output of the image by again clicking on it and turning off the the output
Click Go to Process

Preview

Grab your glue and your backing of choice
You can also use UV Resin to attached the backing.
If you are using UV Resin go ahead and resin the front to give it a more polished look and to protect the print!
If not using resin, you can spray the front with some more modge podge for protection.

Comments