HomeTemplatesTools & Special MaterialsSpecial Materials
Scott
Report
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

XCS image acquisition sticker holders for honeycomb

Instruction
Camerastickerholders.xcs
Camerastickerholders
.xcs
Application scenario
Laser processing
Machine & module
xTool S1
40W
Compatibles · 10
Material used
3mm Basswood Plywood
22
393
Information
      Inserts for the S1 honeycomb to hold the image acquisition stickers
Instruction
1
Step1

I would first refer you to the following xtool link and follow the instructions for placement within the machine:

 https://support.xtool.com/article/1299

 

After you have printed your markers from the link above then cut this project from 3mm basswood and glued the pieces together. Next paint with black paint or use a black sharpie on the platform section before gluing the marker pieces to the center. (not painting the platform piece will cause the XCS camera acquisition to fail).

Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1
3mm Basswood Plywood
3mm Basswood Plywood

License

CC BY