Report
![[Laser cut and engrave] Mountain shaped wooden earrings with snow-capped peaks](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/b7386ad0-ca41-476a-9193-9245f7067d88?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Mountain Stud Earrings
Instructiongora
.xcs
Application scenario
Laser processing
Machine & module
xTool F1
2W, 10WCompatibles · 10
Material used
1/8"(3mm) Basswood Plywood
112
401
Information
Minimalist Mountain shaped wooden earrings with snow-capped peaks.
Instruction
1
Step1: Cut the design and paint it
Preview
Upload the file to XCS and cut it. For best results use masking tape if cutting on the F1 as it simplifies the painting process due to no burn marks. I recommend using acrylic painting pens as the tips are very thin and simplify painting smaller designs.
2
Step2: Apply the stud blank with glue
Preview
Apply a generous amount of superglue to the back of the previously cut earrings and add the stud blanks. Apply some pressure to assure proper adhesion. Set aside to fully cure.
Comments
