Open xcs file in creative space. Make sure you are on SIDE ONE Canvas. Customize the names and message to your liking and font. Check that the engrave and cutting speeds are set to your machine. The cupid speed is better if set at lower speed and lower power as the laser jitters a bit at high speed because of the different power setting it has to use while engraving the image. Note: If using the svg files then you will have to set the cupid image as a sketch. Engrave and cut.

If you want to engrave the back side then you will have to flip your cut project and allign it with the laser. If you have a camera laser then it is easy but if you have a D1 and such, then the easiest way is to select SIDE 2 Canvas and select just the outside layer as you output. Have it score a 0% power and adjust your project so the scoring runs around the outside as if it was cutting. Change your text to the same as the other side and have it engrave side two. Let the scoring run at 0% as well so it engraves on the right spot. Clean with rubbing alcohol and colour if you wish. Add a string or whatever you have at home and hang. For an air freshner, spray with perfume. Enjoy!!