HomeTemplatesDecorHome DecorLighting
maureen.nemetski
Report
Laser cut and engrave Engraved illuminated glass panel with space and telescope design
Project made with xTool P2S machine for Laser cut and engrave.
Project made with xTool P2S machine for Laser cut and engrave.
Laser cut and engrave Engraved illuminated glass panel with space and telescope design
Project made with xTool P2S machine for Laser cut and engrave.
Laser cut and engrave Engraved illuminated glass panel with space and telescope design
Laser cut and engrave Engraved illuminated glass panel with space and telescope design
Laser cut and engrave Engraved illuminated glass panel with space and telescope design
Laser cut and engrave Engraved illuminated glass panel with space and telescope design
Laser cut and engrave Engraved illuminated glass panel with space and telescope design
Laser cut and engrave Engraved illuminated glass panel with space and telescope design

Space Explorations Acrylic Light

Instruction
SolarSystemLight.xcs
SolarSystemLight
.xcs
Application scenario
Laser processing (50min)
Machine & module
xTool P2S
55W
Material used
3mm Clear Transparent Glossy Acrylic
LED stand
324
2053
Information
      My son loves everything to do with space. So I made this illuminated engraving for his room.

I used AImake to generate the bitmap image (3D Engraving - Hologram, with the prompt: solar system galaxy sun planets comets stars telescope). Then I maximized the sharpness, saturation, and contrast (all set to 50) and inverted the image in XCS. I also added a 0mm offset line to enclose the picture and added tabs on the bottom to slot into the wooden LED stand. I united the offset rectangle and tabs, and set them to cut. (I used the stands from these sublimation blanks by PYD: https://a.co/d/fVplRsR ) I processed the design on 3mm clear acrylic, and less than an hour later, I had a unique piece of art to brighten a little explorer's day!
Instruction
1
Step1: Process on clear transparent acrylic

Open the project in XCS and process on clear acrylic. Adjust settings as needed for your laser. You may also need to edit the cut lines to fit the LED stand you are using.

 

If using a different laser processing software, be sure to increase the sharpness, contrast, and saturation of the image, and invert the image prior to processing. I recommend Jarvis mode with 200 lines per cm and bi-directional engraving.

 

After you engrave and cut the acrylic, use a soft cloth to wipe off any debris. Then slot it into the LED stand, turn the light on, and enjoy!

Comments
Remixes
xTool Supplies Used in This Template
xTool P2S
xTool P2S

License

CC BY-NC-SA
This work contains AI-generated content.