Report
Valentine's Day 'Be Mine' banner with heart decorations
Instructionvalentinebanner
.xcs
Application scenario
Laser processing (60min)
Machine & module
xTool S1
40WCompatibles · 8
Material used
3mm Pine Plywood
5
217
Information
valentines banner for seasonal decor change
Instruction
1
Step1: Prepare the Wood
- Apply Mod Podge: Brush a thin layer of Mod Podge on the 3mm plywood boards and let it dry completely.
- Iron on Colored Paper: After the Mod Podge has dried, iron the colored paper onto the wood using a low heat setting. Ensure it’s adhered smoothly.
2
Step2: Paint and Cut the Design
- Paint the Wood: Paint the wood to create the necessary elements for lettering and hearts. Allow it to dry completely.
- Cut with X Tool S1: Using your X Tool S1, cut out the painted wood pieces, including the rectangles for the bunting, scalloped edges, and the lettering.
Step 3: Assemble the Bunting
3
Step3: Assemble the Bunting
- Glue Pieces Together: Glue the wooden pieces together, starting with the rectangular bunting on the bottom, then adding the scalloped bunting on top, followed by the lettering.
- Allow to Dry: Let the glue dry completely before moving on.
4
Step4: Step 4: Attach the Ribbon
- Prepare Ribbon: Tie a 9-inch piece of ribbon through the holes of each bunting block.
- Finish with Longer Ribbons: At both ends of the bunting, tie 2 feet of ribbon to give it the ability to hang easily.
- Seal Ribbon Ends: Use a lighter to carefully burn the ends of the ribbon to prevent fraying and to keep them secure within the holes.
Comments
Remixes
xTool Supplies Used in This Template