HomeTemplatesDecorHome DecorShelves & Holders
LittleLaserCraft
Report
[Laser cut and engrave] Towel hook for heater
Project made with xTool S1 machine for Laser cut and engrave.
[Laser cut and engrave] Towel hook for heater
[Laser cut and engrave] Towel hook for heater

Towel hook for heater

Instruction
towelhook.xcs
towelhook
.xcs
Application scenario
Laser processing (10min)
Machine & module
xTool S1
40W
Material used
or 4mm Plywood
1/8"(3mm) Basswood Plywood
19
292

Information

      Multi-layer towel rack for radiator heater with snap-on design

Instruction

1

Step1: Preparation

Towel hook for heater instruction: step 1 - Preparation
Preview
  1. Open the file in xTool Creative Space. 
  2. Place the wood on top of the honeycomb. Secure with tape, so that nothing moves. 
  3. Choose your preferred settings (3mm Plywood or 4mm Plywood)

 

Note: If you opened the XCS file, all settings are already set-up for use with the S1 40w. You can also scale it up or down if you need other dimensions for your heater.

2

Step2: Cut it

Towel hook for heater instruction: step 2 - Cut it
Preview
  1. Start your machine and experience the wonder of modern technology ;-) 
3

Step3: Glue it together

Towel hook for heater instruction: step 3 - Glue it together
Preview
Towel hook for heater instruction: step 3 - Glue it together
Preview

Glue it together flush and let it dry properly with a little bit of wood glue. 

4

Step4: Optional

You can sand it down to remove the smell and scorch marks. Then, spray it with waterproof clear varnish and now you can even hang damp towels on it.

5

Step5: Snap it in and done

Towel hook for heater instruction: step 5 - Snap it in and done
Preview
Towel hook for heater instruction: step 5 - Snap it in and done
Preview

With a little bit of force at the bottom of the hanger, you can easily snap it in, as shown in picture one

Comments

Remixes

xTool Supplies Used in This Template

xTool S1
xTool S1
1/8"(3mm) Basswood Plywood
1/8"(3mm) Basswood Plywood

License

CC BY-NC