Report
Acrylic Butterfly Decorative Painting
InstructionAcrylicbutterflydecorativepainting
.xcs
Application scenario
Laser processing (180min)
Machine & module
xTool P2
55WMaterial used
300*300*2mm Gradient acrylic board
300*300*3mm Water ripple acrylic board
300*300*3mm Mirror acrylic board
300*300*3mm Luminous acrylic board
300*300*6mm Transparent acrylic
35
613
Information
Use different acrylic materials to make acrylic butterfly decorative paintings! Shining under the light, exquisite and beautiful!
Instruction
1
Step1: Import the XCS file
Preview
Preview
Start the machine, open the xTool Creative Space on the computer, drag in the required XCS file, adjust the parameters.
2
Step2: Laser cutting
Preview
Preview
Preview
2 More images
1. Place 3mm mirror acrylic and select the black layer for laser cutting.
2. Place 3mm water ripple acrylic and select the red layer for laser cutting.
3. Place 3mm gradient acrylic and select the purple layer for laser cutting.
4. Place 3mm luminous acrylic and select the orange layer for laser cutting.
5. Place 6mm transparent acrylic and select the blue layer for laser cutting.
3
Step3: Assembly
Preview
Preview
Preview
5 More images
Paste the obtained components.
- Stick multiple layers of circular rings onto a 6mm base plate (pay attention to finding the correct position)
- Glue a 4mm acrylic rod to the mirror acrylic wings with UV glue and reinforce the lamp.
- Mark the position of the 2 * 50mm acrylic rod at 40mm, and use UV glue to bond it with the water ripple acrylic component for lamp reinforcement. Then, at the top of the 2 * 50mm acrylic rod (10mm away from the water ripple acrylic), use UV glue to bond the gradient acrylic component for lamp reinforcement.
- Use UV glue to bond the 2 * 70mm acrylic rod with the hole in the frame of the luminous acrylic, and reinforce the lamp.
- Use UV glue to bond the 2 * 75mm acrylic rod with the mirror acrylic star, reinforce the lamp, and then pass the component through the hole in the middle of the luminous acrylic component obtained in the previous step, level the bottom, and use UV glue to bond the two components together at the hole, reinforce the lamp.
- Insert the components one by one according to the holes on the 6mm base plate, and then use UV glue to reinforce the lamp.
- Decorate the whole with pearl thread according to your preferences.
Comments
Remixes
xTool Supplies Used in This Template