samh1967
Report

Lotus Wax Seal Stamp - Brass

Instruction
LotusWaxSealStamp.xcs
LotusWaxSealStamp
.xcs
Application scenario
Laser processing (58min)
Machine & module
xTool F1 Ultra
20W
Material used
brass Blank Wax Seal Stamp
122
915
Information
      My design and settings for the Brass Wax Seal Stamp - Lotus
    
Instruction
1
Step1: Click on the “Open in XCS” Button to open this project

Open project in DesignFind

2
Step2: Place item onto the bed of the Ultra

Ensure surface has been cleaned and is free of finger prints etc.

3
Step3: Adjust focus

I find clicking on the “Refresh Background” Camera Icon first, then (if you want to autofocus) clicking on the “Auto-Measure” Icon .  Please do not change the material from <User Defined> as this will cause the entire print to come out wrong.

4
Step4: Framing

Select and move to approximately where you want it on the piece, then click the “Framing” Button (lower right) and again select all (DesignFind unchecks as soon as you click on Framing) then manually move the design so that it is where you want it on your piece. Click on the “Stop Framing” button.

5
Step5: Engrave

Stop the framing on your machine.  Close the shield and press the “Process” button.  Click the “Start” button.  Go over to the F1 Ultra Control Panel and Click to start engraving.  Once it has finished, ensure you wait till the stamp has cooled (it gets hot - ask me how I know).  Once cooled completely, take it out and clean up, I use some water, dishwashing liquid and an old toothbrush to clean up.  It is now ready to make some wax seals.  Enjoy!

Comments
Remixes
xTool Supplies Used in This Template
xTool F1 Ultra
xTool F1 Ultra