Report
![[Laser cut and engrave] Charcuterie Board](https://image-res.xtool.com/resource/xtool%2Fcommunity%2Fmaking%2F1c4d366d-5bd4-4990-9e20-ca16d62e0a38%2FCharcuterie%20Board%202.jpg?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Charcuterie Board
InstructionCharcuturie Board
.xcs
Application scenario
Laser (100min)
Machine & module
xTool S1
40WMaterial used
Acacia
Cutting Board
1856
10520
Information
I got an acacia wood charcuterie board for 40% off at Hobby Lobby. I downloaded the image from Adobe Stock and moved it to XCS. Engrave-75% Power, 85 Speed, 100 Sharpness, 120 lines per cm, Grayscale Bitmap.
Instruction
1
Step1: Measure Work Space
Measure work space as described by Xtool s1 requirments
2
Step2: Adjust File Size to Workspace
Ensure the downloaded file fits within the desired workspace
3
Step3: Adjust Settings
Adjust settings to Engrave, Power-75%, Speed-85mm/s, Sharpness- 100, Grayscale Bitmap, 120 lines per/cm
4
Step4: Frame and Engrave
Click the Process Button on XCS, Frame, and Start
5
Step5: Sand and Wash
Lightly Sand with between 180 and 220 grit sandpaper then Wash with warm water and soap. Fibers will be raised on the board.
6
Step6: Sand and Wash
Lightly sand again, lightly wet is ok, wash again with soap and warm water
7
Step7: Optional Oil
Add a light coat of food-safe mineral oil, I used Caron & Doucet Cutting Board oil as shown in the picture.
Comments