station22woodworking
Report

Puppy Magnets

Instruction
dalmation magnets.xcs
dalmation magnets
.xcs
Application scenario
Laser
Machine & module
xTool D1 Pro
20W
Compatibles · 11
Material used
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
120
1073

Information

      Simple magnets 
    

Instruction

1

Step1: Create a Design

Puppy Magnets instruction: step 1 - Create a Design
Preview

Coming up with an Idea is one of the most difficult I tend to spend a lot of time bouncing around the internet and then going into Canva to design. I then upload it to the XCS and and depending on the material thats when I come up with whats next.

2

Step2: Cutting and adding the magnets

Puppy Magnets instruction: step 2 - Cutting and adding the magnets
Preview
Puppy Magnets instruction: step 2 - Cutting and adding the magnets
Preview

So now that you have your design, we now get to cut it out! This is the fun part where shelly comes into play and she loves to burn and cut, lining up your project is a bit difficult at times I like to use a rafter square and line it up with the outside rale then I make sure by using the laser guides on the laser head to make sure it is squared. After cutting your design out I use two of the magnets on each of these so that they stick a bit better. And now you just enjoy your new magnets!

Comments

Remixes

xTool Supplies Used in This Template

xTool D1 Pro
xTool D1 Pro
1/8"(3mm) Basswood Plywood
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
3mm Basswood Plywood