The XCS file can be used for the processing of both wooden and acrylic versions. 

After processing is completed, get all the components ready.
 

First, tear off all the protective films on the acrylic sheets and set them aside for later use.

Assemble the internal bracket of the flower.

Place the assembled bracket onto the bracket fixing plate, and pay attention to aligning the large and small holes with the corresponding positions on the acrylic. 

Fix the music movement turntable and the adapter plate with screws.

Place the flower bracket assembly upside down on the table and install the adapter plate of the movement turntable. Glue is required for fixation. 

Install the three layers of petals in the order from the outside to the inside and from large to small successively. 

Note: Do not install them in the wrong positions. 

Place the music movement according to the wire frame positioning, and then fix it with screws from the back. 

Install the base support plate.

Install the base cover plate.

Install the light strip.
When using transparent materials, you can install light strips inside the base.

Install the side baffle of the base.

Connect the assembled lotus flower and the base together by screwing. After aligning the centers, rotate counterclockwise horizontally. 
You can hold the lotus petals with your hand and rotate them counterclockwise to wind up the music box. About five turns should be enough. 
 

ps:Over-forcing the rotation or dropping it from a height may damage the movement of the music box.