Import the XCS file into the software and confirm the dimensions, processing positions, and processing modes. Note: For this case, the file uses blank self-adhesive stickers and 3mm transparent acrylic. If the type and thickness of the materials you choose are different, please adjust the laser processing parameters and the file dimensions according to the actual materials.

Put the self-adhesive stickers into the processing area of M1 Ultra and make sure the material is flat. Then select the combined processing and use the inkjet head and fine cutting knife to process the blank self-adhesive stickers in turn, and carry out the layout processing according to the actual situation of the material. Note: The processing parameters marked here are the officially recommended parameters for blank self-adhesive stickers. If you prefer different results, please adjust them manually.

Put the 3mm transparent acrylic into the P2 processing area and make sure the material is flat. Then select the honeycomb plate processing and use the line cutting to process the 3mm transparent acrylic, and carry out the layout processing according to the actual situation of the material. Note: The processing parameters marked here are the officially recommended parameters for 3mm transparent acrylic. If you prefer different results, please adjust them manually.

Stick the self-adhesive stickers onto the 3mm transparent acrylic. Use acrylic glue to bond the middle and lower layers, and use dowels to connect the upper layer.