HomeTemplatesDecorHome DecorDoor Sign
Herb THE berT
Report
[Laser cut and engrave] Welcome sign
Project made with xTool M1 machine for Laser cut and engrave.
Project made with xTool M1 machine for Laser cut and engrave.
[Laser cut and engrave] Welcome sign
Project made with xTool M1 machine for Laser cut and engrave.
[Laser cut and engrave] Welcome sign
Project made with xTool M1 machine for Laser cut and engrave.
[Laser cut and engrave] Welcome sign
[Laser cut and engrave] Welcome sign
[Laser cut and engrave] Welcome sign
[Laser cut and engrave] Welcome sign
[Laser cut and engrave] Welcome sign
[Laser cut and engrave] Welcome sign

Welcome sign

home.xcs
home
.xcs
Application scenario
Laser (60min)
Machine & module
xTool M1
10W
Material used
magnet
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
141
1714

Information

      I took a border in XCS for engraving. i set an outline with 0.1mm for the cutting
at the 4 corners of the sign i glued a magnet.
The O from the HOME is not engraved becaus here is also a magnet.
attention wenn you glue the other magnets on the attachments that you glue it on the right side, 
On my first attempt, the attachments pushed off the shield :)
Comments

Remixes

xTool Supplies Used in This Template

xTool M1
xTool M1
1/8"(3mm) Basswood Plywood
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
3mm Basswood Plywood

License

CC BY-NC