cut out all the bits in the relevant colours.

If you are planning to scale this model up please be aware that the 3mm plastic is integral to the model size.  

glue the wings on to the two side panels

glue the neck onto the two side panels as shown

you can then glue on the back section

glue in the eyes and attach the two yellow parts of the beak followed my the red woggle square.

The legs can be glued to the chicken bottom as shown.

the legs and bottom can now be glued into the body followed by the back end /tail

the back of the head square can be glued in place followed by the face

the two yellow feet can now be glued to the base and then the chicken legs slot into the two holes and glued into position.

you are done