HomeTemplatesDecorHome DecorDesk Decor
djbrandy64
Report
Laser cut and engrave
Project made with xTool D1 Pro machine for Laser cut and engrave.
Project made with xTool D1 Pro machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Clock design

Instruction
Basic Clock Design.xcs
Basic Clock Design
.xcs
Application scenario
Laser
Machine & module
xTool D1 Pro
Compatibles · 8
Material used
Birch Plywood
79
688
Information
      This is a clock in memoriam of Mr. Buffet which I grew up listening to his music.  The great thing about this is you can change the numbers to standard numbers, but be careful on the double digit numbers they have to be a bit realigned as you set them.
Instruction
1
Step1

Unfortunately the "Pine Board" is not selectable...the cut is 12" x 12" which makes the alignment of all the numbers much better when you go from the center out.  I did drill a hole through the material to mount the clock kit (you can get a 1/2" or 3/4" kit).  I painted with paint markers that you can purchase at Wal Mart to get the fine lines painted.

Comments
Remixes
xTool Supplies Used in This Template
xTool D1 Pro
xTool D1 Pro