HomeTemplatesDecorHome DecorShelves & Holders
FuzzyPeach
Report
[Laser cut and engrave] Acoustic Guitar Wall Hanger
Project made with xTool M1 machine for Laser cut and engrave.
Project made with xTool M1 machine for Laser cut and engrave.
[Laser cut and engrave] Acoustic Guitar Wall Hanger
Project made with xTool M1 machine for Laser cut and engrave.
[Laser cut and engrave] Acoustic Guitar Wall Hanger
Project made with xTool M1 machine for Laser cut and engrave.
[Laser cut and engrave] Acoustic Guitar Wall Hanger
[Laser cut and engrave] Acoustic Guitar Wall Hanger
[Laser cut and engrave] Acoustic Guitar Wall Hanger
[Laser cut and engrave] Acoustic Guitar Wall Hanger
[Laser cut and engrave] Acoustic Guitar Wall Hanger
[Laser cut and engrave] Acoustic Guitar Wall Hanger

Acoustic Guitar Wall Hanger

Instruction
GuitarHanger3-16thsinchplywood.xcs
GuitarHanger3-16thsinchplywood
.xcs
Application scenario
Laser processing
Machine & module
xTool M1
10W
Accessories
xTool M1 Air Assist Set
Material used
5mm plywood of any kind.
1/8"(3mm) Walnut Plywood
73
655

Information

      This hanger is made from 5mm  and all parts are glued together with PVA glue.  All parts can fit on a single  256mm x 380mm size of plywood and be worked by an M1 laser all in one session.  

I had the material set to 3mm walnut plywood in the pre-sets but I used 5mm red oak plywood.  Material thickness was manually selected at 5mm. Air Assist was up full blast.  I was able to cut through in one pass.

This was measured and made for a full sized Yamaha FGX800C acoustic guitar.  But it should work for most guitar necks I believe.

edit: I have now included a cut file for those who are using 3/16" thickness plywood

Instruction

1

Step1

Load 5mm plywood onto workspace and cut out all parts.

2

Step2

Glue parts together.  I glued parts up in similar pairs first then assembled all parts.  The last piece to put on is the which you need to just line up as flush as possible.

 

After all parts were in place I ‘clamped’ it together by wrapping painters tape around it in a few spots.

3

Step3

Remove tape and sand any glue  off.  Spray with clear coat or your favourite finish.

Comments

Remixes

xTool Supplies Used in This Template

xTool M1 Air Assist Set
xTool M1 Air Assist Set
xTool M1
xTool M1
1/8"(3mm) Walnut Plywood
1/8"(3mm) Walnut Plywood

License

CC BY