Business card holder

Instruction

businesscardholder

.xcs

Application scenario

Laser processing (25min)

Machine & module

xTool S1

20W

Material used

MDF

Stainless steel

Glue

Business cards

142

1475

Information

      My take on a business card holder made for an office or shop.

Preview

This project starts with an oval from the shapes list, it is copied and pasted to become longer
Once the 3 ovals are in place they are united to become longer.
With the line feature a short line on a slight angle is created and the the array is used to create multiple lines.
These lines are doubled side by side to widen the cut
Then they are placed on the longer oval to be cut out.
The front of this new oval is cut off in the same angle as the slots.
A hole is create the exact same size as the steel tubing to have a tight fit.
All of the pieces are copied so there are 2 of everything
A face plate with Take one is also cut and is used in the front.
Once everything is cut and engraved the assembly starts.
This is done with the steel tube sliding through the hole on 2 of them and the second piece with no hole is glued on to match.
The front part is glued along the 2 ends in the front and the business card are ready to be displayed.

Comments

xTool S1