Report
![[Laser cut and engrave] Emotional support co-worker keychain on red mat](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/a8597d00-471b-4542-877f-faa385bfaa62?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Emotional support co-worker keychain
Instruction
ESCW
.xcs
Application scenario
Laser processing (5min)
Machine & module
xTool M1 Ultra
10WCompatibles · 13
Accessories
xTool M1 Riser Base with Honeycomb Panel
Material used
1/8"(3mm) Walnut Plywood
31
371
Information
A wooden engraved keychain that shows what my unofficial position at work is
Instruction
1
Step1
- Using the honeycomb base, set your material into your machine.
- Measure the distance and check your framing.
- Once everything is all set you can start your engraving and cutting.
- After your keychain is cutout. Remove your piece from the machine. (There might still be a little piece in the space for the jump ring, if so just use a pin to push it out.)
- Thread an open jump ring through the designated hole and add the split ring before closing the jump.
- Gift this fabulous keychain to that one co-worker that is always there for you!
Comments
