HomeTemplatesOffice & StationeryStationery Supplies
comp56
Report
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Bamboo Engraved Pens

Instruction
pens.xcs
pens
.xcs
Application scenario
Laser processing (0.3min)
Machine & module
xTool S1
20W
Material used
bamboo pens
flexible fixture
111
838
Information
      This engraving was done on several bamboo pens using the new flexible fixture from xTool. The simple repeating action is worth it's weight in gold.
Instruction
1
Step1: Set Up
Preview
Preview
Preview
  1. This project doesn't need much design work
  2. The font is selected and it is positioned on the work area of xcs software upside down
  3. This follows the pen length
  4. With the Flexible Fixture in place the distance is set and the marking is made for the length of pen
  5. When the engrave settings are adjusted for bamboo it is sent to be processed
  6. When the pen is finished it is simply replaced with a new one and the process is repeated for each pen.
  7. With the flexible fixture set the pen sits the same way every time so ne adjustments are needed. 
  8. After you are done the amount of pens you wish to engrave they are ready to start writing.
Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1

License

CC0