HomeTemplatesOthers
comp56
Report
Laser cut and engrave Wall vent with electrical outlet on a gray wall
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave Wall vent with electrical outlet on a gray wall
Laser cut and engrave Wall vent with electrical outlet on a gray wall

Air Vent

Instruction
4x10vent.xcs
4x10vent
.xcs
Application scenario
Laser processing (25min)
Machine & module
xTool S1
20W
Material used
3mm marble MDF
2 sided tape
8
201
Information
      Well when you need a vent and you have an xTool no worries......just make one.
Instruction
1
Step1: Designing
Preview
Preview
Preview
2 More images
  1. This project starts with a rectangle 11" x5" in size
  2. This rectangle has it's corners set to a small radius
  3. Once the outside is ready the vents are added
  4. This was done the same way by just adding thin rectangle and giving it radius corners. 
  5. Then this was copied and pasted to be side by side with equal spacing from each end and the middle
  6. Once the first 2 vents were in place the grid array feature was used to create more venting holes
  7. With the amount selected to fill the area they were spaced out to be equal.
  8. After the entire vent was designed it was set to be cut and was sent to be processed.
  9. Once finished the new vent was cleaned off with a cloth and 2 sided tape was added to adhere to the wall.
Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1

License

CC0