Kingfisher Acrylic Light
Instruction
The kingfisher-shaped lamp's wings are mainly in darker blue. Its abdomen feathers are lighter with variations. The body and head are split into two lighting areas for the lighting effects to match the feather colors. Equipped with a sound sensor, it supports sound-reactive mode and allows adjustments of brightness, colors and effects via a smartphone or infrared remote, moving rhythmically with sound or mood. Make your desktop more colorful and artistic.
Align the edges of H1 with H2, B1 with B2-1 and B2-2 respectively, and then fix them by gluing.
Then assemble H and B together and fix them by gluing. Pay attention to making the outer seams connect tightly as much as possible.
Insert the latch into the slot of B2-2 and install the two inner side panels.
Remove the protective film on the acrylic plate. Align the edge of the acrylic with the edge of the light strip groove on the inner side of the wooden board, and then fix them by gluing.
(Tip: Before fixing the acrylic with glue, you can try installing the light strip first to prevent the width of the subsequent light strip groove from being too narrow so that the light strip cannot be installed.)
Attention must be paid! Make sure that the glue doesn't overflow to the outside of the acrylic, otherwise it will seriously affect the appearance. Attention must be paid! Make sure that the glue doesn't overflow to the outside of the acrylic, otherwise it will seriously affect the appearance. Attention must be paid! Make sure that the glue doesn't overflow to the outside of the acrylic, otherwise it will seriously affect the appearance. Attention must be paid! Make sure that the glue doesn't overflow to the outside of the acrylic, otherwise it will seriously affect the appearance. Attention must be paid! Make sure that the glue doesn't overflow to the outside of the acrylic, otherwise it will seriously affect the appearance. Attention must be paid! Make sure that the glue doesn't overflow to the outside of the acrylic, otherwise it will seriously affect the appearance. Attention must be paid! Make sure that the glue doesn't overflow to the outside of the acrylic, otherwise it will seriously affect the appearance.
Since the light strip is rather long, you can cut off the last six LEDs first, and then start installing the light strip from the triangular groove inside the beak of the kingfisher. Pay attention to bending it along the triangular edge here, so that one of the LEDs faces the tip of the beak. Then carefully embed the LED light strip into the light strip groove.
Don't use too much force when pressing down or bending the light strip, otherwise the circuit may be broken.
Insert the bottom baffle, cover the outer components, and fasten them with glue. Pay attention to aligning the edges.
Finally, insert the foot support into the notch above the outlet of the LED light strip terminal to complete the assembly. (Acrylic is rather brittle, so be careful during installation.)
Connect to the controller. After powering on, you can use the infrared remote control to switch the lighting effects.