Parrot acrylic lamp
Instruction
Light up the parrot's wings and light up your world! Inspired by geometric design, this macaw table lamp combines colored MDF (Medium Density Fiberboard) with frosted transparent acrylic perfectly, outlining an artistic shape that is minimalist yet has clear layers. Under the illumination of the RGB LED light strip, the parrot's wings seem to shine like real feathers in the sunlight. The light dances with the rhythm of the sound, just like the parrot singing and dancing joyfully. Meanwhile, it supports infrared remote control to adjust the light effects, allowing you to change the desktop atmosphere as you like. This is not only an exquisite decoration but also a sound-activated ambient light that combines modern geometric aesthetics with the charm of technology, making life full of colors and an artistic sense!
Turn on the machine, open xTool Creative Space on the computer, drag in the required xcs files, put them in order in sequence, select the mode of combined processing, set up the mode processing of inkjet and laser respectively. Confirm the parameters and do the preparation work before processing.
Fix the two boards together by using a latch plate.
Align the outer board with the opposite board and clamp them firmly. Wood glue or quick-drying glue will be needed. Be careful not to let the glue overflow.
Stick on the parrot's black beak and eyeballs.
Install the second inner head board and clip it onto the latch plate.
Align the acrylic body part with the wooden board part and clamp them firmly. Then fix them with glue from the inside.
ps:Attention must be paid! Make sure that the glue doesn't overflow to the outside of the acrylic, otherwise it will seriously affect the appearance effect.
Insert the light strip into the light strip guide groove. Pay attention to first clip the light strip terminal at the outlet. If a 60-cm-long light strip is used, there will be an extra part. If you don't want to cut the light strip, you can first align the end with the terminal and clip it tightly at the outlet of the groove. Then bend the extra part inside the groove space. Don't apply too much force at the bending point, otherwise the circuit may be broken.
Stick on the beak and eyeballs on the other side.
Finally, insert the foot support into the notch above the outlet of the LED light strip terminal to complete the assembly.
Connect the controller. After powering on, you can use the infrared remote control to turn the light on or off and switch the light effects.