HomeTemplatesHome DecorCoaster
comp56
Report
[Laser cut and engrave] Intricate wooden coasters with Santa Claus engravings
Project made with xTool S1 machine for Christmas.
Project made with xTool S1 machine for Christmas.
[Laser cut and engrave] Intricate wooden coasters with Santa Claus engravings
Project made with xTool S1 machine for Christmas.
[Laser cut and engrave] Intricate wooden coasters with Santa Claus engravings
Project made with xTool S1 machine for Christmas.
[Laser cut and engrave] Intricate wooden coasters with Santa Claus engravings
[Laser cut and engrave] Intricate wooden coasters with Santa Claus engravings
[Laser cut and engrave] Intricate wooden coasters with Santa Claus engravings
[Laser cut and engrave] Intricate wooden coasters with Santa Claus engravings
[Laser cut and engrave] Intricate wooden coasters with Santa Claus engravings
[Laser cut and engrave] Intricate wooden coasters with Santa Claus engravings

Santa Wooden Coasters

Instruction
Santacoasters.xcs
Santacoasters
.xcs
Application scenario
Laser processing (45min)
Machine & module
xTool S1
20W
Material used
3mm birch
Beeswax sealer
256
1425

Instruction

1

Step1: Project Prep

Santa Wooden Coasters instruction: step 1 - Project Prep
Preview
  1. All 4 different images were from AImake
  2. All of them brought into XCS software
  3. Once in the software they are all sized
  4. A rectangle is created with a small radius on the corner so they are rounded and not sharp
  5. Each image from the set of 4 are engraved and cut to the same size with the created rounded square
  6. When the settings are adjusted the project is sent to the machine to be processed. 
  7. This can be done 1 image at a time or all 4 at one time
  8. When finished the new engraved coasters are cleaned and then a good coat of beeswax is applied to seal them.
Comments

Remixes

xTool Supplies Used in This Template

xTool S1
xTool S1

License

CC0
This work contains AI-generated content.