![[Laser cut and engrave] Swan Acrylic Lamp](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/50ab0d30-03f7-4d68-a511-da27d496f144?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Swan Acrylic Lamp
Instruction
Information
This elegant swan table lamp is crafted with laser-cut colored MDF and dual-sided frosted acrylic sheets, paired with RGB light strips for soft illumination and dynamic lighting effects. Equipped with a sound sensor, it supports sound-reactive mode and allows adjustment of brightness, colors, and effects via a smartphone or infrared remote. Perfect for decoration or ambient lighting, this swan lamp adds a touch of charm and warmth to any space.
Instruction
Step1: Import the XCS file
Turn on the machine, open xTool Creative Space on the computer, drag in the required xcs files, put them in order in sequence, select the mode of combined processing, set up the mode processing of inkjet and laser respectively. Confirm the parameters and do the preparation work before processing.
Step2: Cut
Step3: Assemble 1
Insert the three rectangular (P1 - P3) boards into the corresponding grooves respectively.
Step4: Assemble 2
Align L1 with L2 and then glue them together. Note that it should be aligned at the top, not at the wavy line at the bottom.
Step5: Assemble 3
Then fix the other components onto L2 by using latches.
Step6: Assemble 4
Remove the protective film on the surface of the acrylic. Align the semicircular protrusions and grooves on the acrylic board with those on LN2 and L3-1, and then assemble them smoothly. A very small amount of glue can be used to fix them from the inside. Be careful not to let the glue overflow so as not to affect the appearance of the work.
Step7: Assemble 5
Find LN2, L3-1 and L3-2. After aligning them, clip the grooves onto the latch plate.
Insert the light strip into the light strip guide groove. Pay attention to first clip the light strip terminal at the outlet. Don't apply too much force at the bending points, otherwise the circuit may be broken (Important reminder!).
The light strip should be folded twice in the guide groove.
Step8: Assemble 6
Align L2 and LN3 and then fix them with glue. Finally, align L1 and fix it with glue as well.
Step9: Assemble 7
Install the head components of the swan and use glue appropriately to prevent the glue from overflowing onto the acrylic board.
Step10: Assemble 8
Finally, insert the foot support into the notch above the outlet of the LED light strip terminal to complete the assembly.
Step11: Complete
Connect the controller. After powering on, you can use the infrared remote control to turn the lights on or off and switch the light effects.
