HomeTemplatesDecorHome DecorShelves & Holders
CarvingCreatives IG
Report
Laser cut and engrave Yarn balls with heart-shaped wooden stand and crochet hook holder
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave Yarn balls with heart-shaped wooden stand and crochet hook holder
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave Yarn balls with heart-shaped wooden stand and crochet hook holder
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave Yarn balls with heart-shaped wooden stand and crochet hook holder
Laser cut and engrave Yarn balls with heart-shaped wooden stand and crochet hook holder
Laser cut and engrave Yarn balls with heart-shaped wooden stand and crochet hook holder
Laser cut and engrave Yarn balls with heart-shaped wooden stand and crochet hook holder
Laser cut and engrave Yarn balls with heart-shaped wooden stand and crochet hook holder
Laser cut and engrave Yarn balls with heart-shaped wooden stand and crochet hook holder

Portable Yarn Holder, Travel Wrist Hanging Yarn Cake Dispenser

Instruction
YarnholderC.xcs
YarnholderC
.xcs
Application scenario
Laser processing (22min)
Machine & module
xTool S1
20W
Compatibles · 10
Accessories
xTool S1 Honeycomb Panel
Material used
3mm Basswood Plywood
89
601
Information
      Portable Yarn Holder, Travel Wrist Hanging Yarn Cake Dispenser, Gift for Crocheter, Gift for her, yarn, crochet, knitting
Instruction
1
Step1

Insert material onto honeycomb Panel.

2
Step2

Auto measure the distance for you material, I used 3mm plywood.

3
Step3

Mark your working area with the rectangle option, this project takes up less than ½ of a 12x12 sheet, can be duplicated to run 2 on one sheet. 

4
Step4

Verify the correct settings for your machine. I ran this project on the S1-20W. Feel free to adjust the power and speeds to your liking. 

5
Step5

Run the project, approx 23 minutes

6
Step6
Preview
Preview

Assemble the pieces together and glue up. If you want you can add the heart etching on the other side before assembly. 

7
Step7

Attach the wristlet, this one was from a local shop but these can be found on Amazon as well. 

8
Step8

Gift to the knitter or crocheter in your family. 

Comments
Remixes
xTool Supplies Used in This Template
xTool S1 Honeycomb Panel
xTool S1 Honeycomb Panel
xTool S1
xTool S1
3mm Basswood Plywood
3mm Basswood Plywood

License

CC BY-NC