HomeTemplatesDecorHome DecorShelves & Holders
bahenry1999
Report
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave

CuttingBoardStand

Instruction
CuttingBoardStand.xcs
CuttingBoardStand
.xcs
Application scenario
Laser processing (7min)
Machine & module
xTool M1
10W
Compatibles · 10
Accessories
xTool M1 Air Assist Set
xTool M1 Riser Base with Honeycomb Panel
Material used
3mm Basswood Plywood
150
953
Information
      This is a stand for cutting boards.  Made from 3mm wood.  To display your fabulous engraved wood projects.  
Designed to hold a cutting board up to approximately 30mm depth.  
Initial file created using boxes generator
https://boxes.hackerspace-bamberg.de/
and customized to add catch for the front edge of the board.
Instruction
1
Step1: Open File in XCS

See attached xcs file and open.

2
Step2: Prepare material and cut
  1. Lay out the material in the M1 workspace
  2. Secure using magnets/painters tape
  3. Turn on air assist and filters
  4. Cut material
3
Step3: Assemble and use
Preview
Preview
  1. The two pieces are sized to just slide together.  
  2. No Glue is needed as long as the fit is snug.
  3. Place on a flat surface and add cutting board.
Comments
Remixes
xTool Supplies Used in This Template
xTool M1 Air Assist Set
xTool M1 Air Assist Set
xTool M1 Riser Base with Honeycomb Panel
xTool M1 Riser Base with Honeycomb Panel
xTool M1
xTool M1
3mm Basswood Plywood
3mm Basswood Plywood

License

CC BY