Cut out all parts.  

It took a little bit of finesse to get the sides into the bottom piece. 

The bottom is the solid square piece with the 4 slots in it.

I used the top part of the frame to center the smaller cut out for the candle top.

Glue it in place and when it is ready flip it over.

Glue the 2 flame pieces together and glue into the top slot.

I left a hole in the lid to add lights if desired.

Again, this needed some careful finger work to all the sides into the slots.

I glued this in place.

Place lid on top and you are done!

I have made other candles and have found putting a folded and cut piece of paper inside distributes the light really nice.  If you use fairy lights, put one thru the lid to make the candle flame look real!

Hope you enjoy this one!

Jeffery

Jeff's fun Laser Hobby